How Do You Install It Correctly When Using Diamond Cutting Tools -- Diamond Wire Saw?

- Aug 30, 2017 -

How Do You Install It Correctly When Using Diamond Cutting Tools -- Diamond Wire Saw? Confirming the direction of the rope saw before installing it, make sure that the direction of the arrow on the rope saw is the same as the sawing direction. There are some rope has been used unable to see the direction of the arrow on the rubber clearly, you can be based on the direction of the diamond particles to identify the right direction of the rope saw.

Penetrate the rope saw from the hole that has been drilled on the surface please note: When cutting the vertical surface, the rope saw's transport direction must follow along from the horizontal hole, piercing from the vertical hole. When cutting the horizontal plane according to the actual location to determine the direction of penetration, rope saw from new to old, the direction of operation should always be consistent. If you use the wire saw with wrong direction, the entire rope saw will have the possibility to scrap. So do not be used together with the new ope and old rope, it will cause a lot of waste and cause broken rope accident.


Previous: Cutting Principle of Diamond Concrete Cutting Machine Next: Pay Special Attention to Operation of Diamond Wire Cutting Machine

Related News

Related Products